Jinan always machinery co. LTD
|
Payment Terms: | T/T,L/C |
Place of Origin: | Shandong, China (Mainland) |
Add to My Favorites | |
HiSupplier Escrow |
Pumping slurry from above the cylinder along the tangent direction into the separation chamber, the centrifugal force generated by high speed rotating impeller to make pulp do circular motion inside the separator, heavier than major impurities in pulp was quickly rotate to the periphery along the wall, heavy slag into the slag system. The light impurities are concentrated in the center under the action of centripetal force, which is discharged by the outlet of the center front end under pressure, and the good pulp after separating the impurities passes through the sieve plate to the next process.
1. The cylinder
The cylinder adopts wear resistance and pressure resistance design standard, material is stainless steel or carbon steel. Pulp by entry along the tangent direction into the cylinder, the rotor high-speed rotation of the centrifugal pulp raw material, and the light impurity separation, light impurity by cylinder gland central discharge, heavy impurities by the principle of centrifugal force, along the cylinder tangent into the sand tank.
2. The rotor
The rotor adopts special shape design, which can effectively separate the weight impurities.
The inside of the rotor is equipped with a clean water pipe to prevent the mesh from being blocked.
The rotor blade adopts replaceable high - wear high - wear strength alloy steel.
The rotor body is cast steel or cast stainless steel.
3. The sieve plate
The aperture of sieve plate is 2.5-6mm
Usually newsprint, magazine paper for the use of 2.5-4mm
Corrugated paper, box board paper is 3.5-6mm fan
The sieve plate is assembled in pieces, easy and easy to replace the sieve plate.
4. Stand
The platform is used to support the main shaft and the slurry inlet pipe connection. The upper part is supported by two bearings supporting the rotor and the driving shaft. The clearance of the rotor and sieve plate is adjustable.
5. Slag discharge system
This part is made of stainless steel, supported by cylinder body.
The operating disc switch is automatically controlled, with two water injection ports for cleaning pressure